Reset service light indicator Skoda Fabia

Reset service light indicator Skoda Fabia. From year: 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013.
How to reset reset service light indicator Skoda Fabia MK1.

  1. With the ignition off, with all doors closed.
  2. Push and hold the button located on the right of the dash board, next to speedometer (km/h), picture below.
  3. Reset service light indicator Skoda Fabia Mk1.
  4. Switch the ignition to on, do not start the car.
  5. Release the button and push again fore one second until the displays “service InSP” indicator, picture below.
  6. Reset service InSP indicator Skoda Fabia Mk1.
  7. Rotat the same button to the right, until service – – –  is displayed, picture below.
  8. Reset maintenance service light Skoda Fabia Mk1.
  9. Now push again the button and that was it, the service interval indicator has been reset.


How to reset reset service light indicator Skoda Fabia MK2.

Reset service light indicator Skoda Fabia Mk2.

It is only possible to reset the Service Interval indicator, if a service message or at least a pre-warning is shown in the instrument cluster display.

We recommend that this reset is completed by a specialist garage.

The specialist garage:

  • resets the memory of the display after the appropriate inspection;
  • adds an entry to the Service Schedule;
  • affix the sticker with the entry of the following service interval to the side of the dash panel on the driver’s side. 

You can reset the service interval display by using the reset button 6 from the above picture.

On vehicles which are equipped with the information display, you can reset the service interval display in the menu Settings.

Reset oil service light Skoda Fabia Mk2.

First read and observe the introductory information and safety warnings.

You can activate the Main menu by pressing the rocker switch A, formore than 1 second.

Individual menu points can be selected by means of the rocker switch A. When the pushbutton B is briefly pressed, the information you have selected is displayed.

The following information can be selected (depending on the equipment installed on the vehicle):

  • MFD
  • Audio
  • Navigation
  • Phone
  • Vehicle status
  • Settings

The menu points Audio and Navigation are only displayed when the factory-fitted radio or navigation system is switched on.

If warning messages are shown in the information display, these messages can be confirmed with the button B, on the windshield wiper lever in order to call up the main menu.

If the information display is not activated at that moment, the menu always shifts to one of the higher levels after 10 seconds.


Settings Skoda Fabia.

You can change certain settings by means of the information display. The current setting is shown on the information display in the respective menu at the top below the line.


The following information can be selected (depending on the equipment installed on the vehicle):

  • Language
  • MFD Data
  • Time
  • Winter tyres
  • Units
  • Alternative speed displayed
  • Service
  • Factory Setting
  • Back

After selecting the menu point Back you will reach one level higher in the menu.

This is where the language in which the warning and information texts should be displayed can be set.

Displays of the MFA
This is where certain displays of the multi-functional indicator can be switched on or off.

The time, time format (12 or 24 hour indicator) and the changeover between summer/winter time can be set here.

Winter tyres
This where the speed at which a warning signal should sound can be set. This function is, for example, used for winter tyres with which the permissible maximum speed is lower than the maximum speed of the vehicle.

When exceeding the speed, the following is shown on the information display:

        Winter tyres: max. speed … km/h

The units for the temperature, consumption and distance driven can be set here.

Second speed
The display of the second speed in mph or in km/h can be switched on here1).

Here you can have the remaining kilometres and days until the next service interval displayed, and reset the Service Interval Display.

Factory Setting
After selecting the menu Factory setting the factory setting of the information display is restored.


That it is the full procedure how to reset service light indicator Skoda Fabia. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Skoda cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.

Click hear to see full procedure how do you reset the oil light indicator. How to reset the maintenance light and how do you reset service light for all Skoda vehicles.

Leave a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.