Reset malfunction indicator light Toyota Sequoia 1 generation. From year: 2005, 2006, 2007.
How to reset malfunction indicator light Toyota Sequoia 1 generation.
This lamp comes on when the ignition key is turned to the “ON” position and goes off after the engine starts. This means that the warning light system is operating properly.
If the lamp remains on or the lamp comes on while driving, first check the followings.
- Empty fuel tank. If the fuel tank is empty, refuel immediately.
- Loose fuel tank cap. If the fuel tank cap is loose, securely tighten it.
These cases are temporary malfunctions. The malfunction indicator lamp will go off after taking several driving trips. If the lamp does not go off even after several trips, contact your Toyota dealer as soon as possible.
If the fuel tank is not empty or the fuel tank cap is not loose.
There is a problem somewhere in the engine, emission control system, electronic throttle control system, automatic transmission electrical system or warning light system itself.
Contact your Toyota dealer as soon as possible to service the vehicle.
If engine speed does not increase when the accelerator pedal is depressed, there may be a problem somewhere in the electronic throttle control system.
At this time, vibration may occur. However, if you depress the accelerator pedal more firmly and slowly, you can drive your vehicle at low speeds. Have your vehicle checked by your Toyota dealer as soon as possible.
Even if the abnormality of the electronic throttle control system is corrected during low speed driving, the system may not be recovered until the engine is stopped and the ignition key is turned to “ACC” or “LOCK” position.
Be especially careful to prevent erroneous pedal operation.
Emissions inspection and maintenance (I/M) programs.
We recommend you to contact your Toyota dealer to check your vehicle’s emission control system and OBD (On−Board Diagnostics) system before taking your vehicle for a state emission inspection.
All information how to reset malfunction indicator light is taken from Toyota Sequoia first generation owners manual.
That it is the full procedure how to reset malfunction indicator light Toyota Toyota Sequoia first generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.
This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.