How to change the master window switch on GMC Sonoma 2001-2004

Do it yourself, change the master window switch on your GMC Sonoma, the model produced between the years 2001 and 2004. You will require a flat blade screwdriver and a new window switch module to make this replacement. The process is very simple and it will take you less than 15 minutes.      In…

DIY, remove the front door panel on GMC Sonoma 1998-2004

Do it yourself, remove the front door panel on your GMC Sonoma, the car model made between the years 1998 and 2004. You will need flat blade and Phillips screwdrivers, a 7 mm socket wrench and a putty knife to do it. Removing and reinstalling the door panel on this car will most probably take you…

How to change the tail light on GMC Sonoma 1994-2004

Do it yourself, change the tail light assembly on your GMC Sonoma, the model produced between the years 1994 and 2004. The only tool you’ll need to make this replacement is a Phillips screwdriver. The whole process will probably take you less than 15 minutes.      First, open the tailgate of your car and start…

DIY, change the headlight on GMC Sonoma 1998-2004

Do it yourself, change the headlight assembly on your GMC Sonoma, the model manufactured in the years 1998, 1999, 2000, 2001, 2002, 2003 and 2004. This replacement can be done in less than 15 minutes, without any tools. In some cases, if the tabs that secure the headlight are stuck and you cannot pull them up by…

How to change the parking brake handle and cable on GMC Sierra 2002

DIY, change the parking brake handle and cable on your GMC Sierra, the model manufactured in 2002. This procedure is the same on models made from 1999 to 2007. The only tool you’ll need is a 10 mm socket with a ratchet, or a wrench. This repair can be done in less than 20 minutes.  …

How to change an ignition coil on GMC Sierra 2002 V8

DIY, change the ignition coils on your GMC Sierra, the model made in 2002, with the Vortec V8 engine. The replacement is the same for most of the models equipped with the 4.8, 5.3 and 6.0L Vortecs. The only tool you’ll need is a 7 mm socket wrench, with a ratchet and extension. The repair is…

DIY, change the license plate light assembly on GMC Sierra 2002

Do it yourself, change the license plate light assembly on your GMC Sierra, the car model made in 2002. This repair is very simple and it will not require tools to do it, just a new assembly from your local hardware store. The replacement can be done in a couple of minutes.      Now,…

How to change the rear door panel on GMC Crew Cab 1999-2002

DIY, change the rear door panel on your GMC Crew Cab, the model made between 1999 and 2002. You will require a 7 mm socket wrench and a flat blade screwdriver to make this replacement. Removing and reinstalling the panel might take you more than half an hour.      First of all, open the rear…

How to change the trailer harness connector on GMC Sierra 1999-2006

DIY, change the 8-pin trailer harness connector on your GMC Sierra. The replacement process described next is similar on most GMC trucks and SUVs and the only tool you’ll need is a small flat headed screwdriver. In some cases you might need some penetrating oil or a similar product to apply on the metal, behind…

How to change the tail light assembly on GMC Yukon 2000-2006

Do it yourself, change the tail light assembly on your GMC Yukon, produced between the years 2000 and 2006. You will only require a Phillips screwdriver to make this replacement and about 10 minutes of your time. The repair can be very simple if you follow the steps below.      First of all, open…