How to change the tail light assembly on Dodge Ram 1994-2001

Do it yourself, change the tail light assembly on your Dodge Ram, the model made between the years 1994 and 2001. You will require a T25 torx driver and probably less than 15 minutes, because this repair is quite simple.      You can start the replacement by opening the tail gate of your car….

How to remove the door panel on Dodge Ram 1994-2001

DIY, remove the front door panel on your Dodge Ram 1500, the model produced between the years 1994 and 2001. You will need a 10 mm socket with a ratchet and extension, a flat blade screwdriver, a Phillips screwdriver and a putty knife. The removal process will take you less than 20 minutes.      After…

How to change the hood latch assembly on Dodge Ram 2002-2008

Do it yourself, change the hood latch assembly on your Dodge Ram 1500, the model manufactured between the years 2002 and 2008. To be able to make the repair, you will need a 10 mm socket wrench, a flat blade screwdriver and a new hood latch assembly. The replacement is very simple and you can do it in less…

How to replace the tailgate handle on Dogde Ram 2002-2008

Do it yourself, replace the tailgate handle on your Dodge Ram. The repair procedure shown below could be similar to models manufactured between the years 2002 and 2008. To be able to make this particular repair, you will require a T30 torx driver and an 8 mm socket wrench. The process is quite simple, it should not take you…

Replace front fog lights on Dodge Ram 1500 2002-2008

How to change the fog lights on Dodge Ram 1500 2002-2008

DIY, change the fog lights on your Dodge Ram 1500 made in the years 2002, 2003, 2004, 2005, 2006, 2007 and 2008. You will require new fog lights from your local store and a 10 mm socket wrench. This simple repair should take you about 15 minutes.      You can access the back of…

How to change the ignition coils on Dodge Ram 1500 Hemi 5.7L

Do it yourself, change the ignition coils on your Dodge Ram 1500 Hemi 5.7L manufactured in the year 2008. For this repair you will need new ignition coils from your local hardware store, a flat headed screwdriver, a 10 mm socket wrench and some dielectric grease. The repair process is not very difficult but it might take you about…

How to replace the alternator on a Dodge Ram 2003-2008

DIY, replace the alternator on your Dodge Ram manufactured in the years 2003, 2004, 2005, 2006, 2007 and 2008. The repair will require a flat blade screwdriver, 10 mm, 13 mm and 15 mm socket wrenches, a 3/8 drive ratchet and about 35 minutes.      Before working with any electrical part on your car,…

How to change the rear door speaker on a Dodge Ram 2002-2008

Do it yourself, change the rear door speaker on your Dodge Ram manufactured in the years 2002, 2003, 2004, 2005, 2006, 2007 and 2008. You will need a Phillips screwdriver, a 10 mm socket wrench and about 20 minutes to do this relatively simple repair.      First, you have to take off the front…

How to change the headlight assembly on a Dodge Ram 2008

How to replace the headlight assembly on your Dodge Ram Facelift 2006, 2007 and 2008. You will need a small flat blade screwdriver, a 10 mm socket wrench and about 30 minutes for this repair.      In the beginning, open the driver’s door and pop-up the hood of your car. There are two 10 mm…