Reset oil service light Pontiac Montana second generation. From years: 2005, 2006, 2007, 2008, 2009.
How to reset oil service light Pontiac Montana second generation.
- Switch ignition to ON, don’t start the car.
- After step one straight away depress and release the accelerator pedal slowly three times within 5 seconds.
- If the warning light for CHANGE OIL SOON light flashes 2 times, the system is reset.
- Switch ignition to OFF, and then to ON again to verify the warning light that indicates to change engine oil has been reset.
If the CHANGE ENGINE OIL message comes back on, the engine oil life monitor has not reset. Repeat the procedure.
The full procedure how to reset oil service light Pontiac Montana second generation is taken owners manual.
When to change the engine oil on your Pontiac Montana second generation. Your vehicle has a computer that lets you know when tochange your engine oil. This is not based on mileage, but on engine revolutions and engine operating temperature. When the computer has calculated that the oil needs changing, the GM Oil Life System will indicate that a change is necessary. The mileage between oil and filter changes will vary depending on how you drive your vehicle — usually between 3,000 miles (5 000 km) and 7,500 miles (12 500 km) since your last oil and filter change. Under severe conditions, the system may come on before 3,000 miles (5 000 km). Never drive your vehicle more than 7,500 miles (12 500 km) or 12 months (whichever occurs first) without an oil change.
The system won’t detect dust in the oil. So, if you drive in a dusty area, be sure to change your oil and filter every 3,000 miles (5 000 km) or sooner. Remember to reset the CHANGE ENGINE OIL message whenever the oil is changed.
Another procedure how to reset oil service light Pontiac Montana second generation.
The Engine Oil Life System calculates when to change your engine oil and ﬁlter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a
CHANGE ENGINE OIL message being turned on, reset the system.
- Turn the ignition to RUN / ON position, one position befor starting the engine.
- Repeatedly depress the trip / reset button until OIL light is displayed on the Driver Information Center (DIC).
- Once OIL warning light is displayed, press and hold the trip/reset button for 5 seconds.
- The number will vanish and be replaced by 100 (indicating 100% oil life remaining).
- Switch OFF the ignition and then start the engine to verify the warning light has been reset.
If the change engine oil message comes back on, the engine oil life monitor has not reset. Repeat the procedure.
All information how to reset oil service light Pontiac Montana second generation is taken owner’s manual.
If this message comes on and stays on after you started the engine, have the oil changed.
When the change engine oil message comes on, it means that service is required for your vehicle. Have your vehicle serviced as soon as possible within the next 600 miles (1 000 km). It is possible that, if you are driving under the best conditions, the engine oil life system may not indicate that vehicle service is necessary for over a year. However, your engine oil and ﬁlter must be changed at least once a year and at this time the system must be reset.
If the engine oil life system is ever reset accidentally, you must service your vehicle within 3,000 miles (5 000 km) since your last service. Remember to reset the oil life system whenever the oil is changed.
When the change engine oil message appears, certain services, checks and inspections are required. Required services are described in the following for “Maintenance I” and “Maintenance II.” Generally, it is recommended that your ﬁrst service be Maintenance I, your second service be Maintenance II and that you alternate Maintenance I and Maintenance II thereafter. However, in some cases, Maintenance II may be required more often.
Pontiac Montana second generation Maintenance I. Use Maintenance I if the change engine oil message comes on within 10 months since vehicle was purchased or Maintenance II was performed.
Pontiac Montana second generation Maintenance II. Use Maintenance II if the previous service performed was Maintenance I. Always use Maintenance II whenever the message comes on 10 months or more since the last service or if the message has not come on at all for one year.
That it is the full procedure how to reset oil service light Pontiac Montana second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Pontiac cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.
This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.