Reset oil service light Mercury Sable. From years: 2008, 2009, 2010.
How to reset oil service light Mercury Sable.
To reset the oil monitoring system to 100% after each oil change on a Mercury Sable [approximately 7,500 miles (12,000 km) or 6 months] perform the following:
- Turn the ignition to run, one position before starting engine.
- Press the SETUP control to enter SYSTEM CHECK, then press SETUP control again to display “OIL LIFE = XXX% HOLD RESET = NEW”.
- Press and hold the RESET control for 2 seconds and release. Oil life is set to 100% and “OIL LIFE SET TO 100%” is displayed.
- While “OIL LIFE SET TO 100%” is displayed, if a lower oil life is desired, press and release the RESET control to reduce the value. Each press of the RESET control reduces the value by 10 percent.
Note: Oil life of 100% equals 7,500 miles (12,000 km) or 6 months. For example, setting oil life to 60% sets the oil life value to 4,500 miles (7,200 km) and 108 days.
OIL CHANGE REQUIRED and CHANGE OIL SOON. Displayed when the engine oil life remaining is 5 percent or less. When oil life left is between 5% and 0%, the CHANGE OIL SOON message will be displayed. When oil life left reaches 0%, the OIL CHANGE REQUIRED message will be displayed.
The full procedure how to reset oil service light Mercury Sable is taken owners manual.
An oil change is required whenever indicated by the message center.
That it is the full procedure how to reset oil service light Mercury Sable. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Mercury cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders when by yourself.
This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.