Reset oil service light Jeep Grand Cherokee SRT-8

Reset oil service light Jeep Grand Cherokee SRT-8. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.

 

How do you reset oil service light Jeep Grand Cherokee SRT-8.

Reset Engine Oil Change Indicator System.
Oil Change Due
Your vehicle is equipped with an engine oil change indicator system. The “Oil Change Due” message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style. 

Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position or cycle the ignition to the ON/RUN position if equipped with Keyless Enter-N-Go. To turn off the message temporarily, press and release the MENU button. To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure. 

How do you reset oil service light Jeep Grand Cherokee SRT-8 for vehicles Equipped With Keyless Enter-N-Go.

  1. Without pressing the brake pedal, push the ENGINE START/STOP button and cycle the ignition to the ON/ RUN position (Do not start the engine.
  2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
  3. Without pressing the brake pedal, push the ENGINE START/STOP button once to return the ignition to the OFF/LOCK position.

How to reset oil service light Jeep Grand Cherokee SRT-8 for Vehicles Not Equipped With Keyless Enter-N-Go.

  1. Turn the ignition switch to the ON/RUN position (Do not start the engine).
  2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
  3. Turn the ignition switch to the OFF/LOCK position.

NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure

All information is taken from the Jeep Grand Cherokee SRT-8 owners manual.

Reset oil service light Jeep Grand Cherokee SRT-8.  Reset oil service light Jeep Grand Cherokee.

 

That it is the full procedure how to reset oil service light Jeep Grand Cherokee SRT-8. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Jeep cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders when by yourself.

 This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.

Click hear to see full procedure how do you reset the oil light indicator. How to reset the maintenance light and how do you reset service light for all Jeep vehicles.

 

2 thoughts on “Reset oil service light Jeep Grand Cherokee SRT-8

  1. I have a figure that appears in red on dash of 2006 jeep Grand Cherokee. Manual says it is notification for state inspection. How do I turn it off?

    1. Please describe the indicator, be careful if the light is red is very bad, don’t start the car if the indicator is yellow (orange) it is not so bad you can start the engine.

Leave a Reply

Your email address will not be published. Required fields are marked *