Reset airbag fault code Range Rover

Reset airbag fault code Range Rover. How to reset the Range Rover Airbag Fault Code warning light. Reset AIRBAG FAULT error message on dash board on a Range Rover.

How to reset airbag fault code Range Rover.

  1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.
  2. Slide the clamp off of the negative battery terminal.
  3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.
  4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.

 

That it is the full procedure how to reset airbag fault code Range Rover. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Land Rover cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders when by yourself.

 This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.

Click hear to see full procedure how do you reset the oil light indicator. How to reset the maintenance light and how do you reset service light for all Land Rover vehicles.

 

2 thoughts on “Reset airbag fault code Range Rover

  1. I have a 2008 Land Rover which has an Air Bag code B001, (Driver Frontal Stage 1 Deployment Control) We have cleared but it returns. I have been told that its a connection problem with wiring. Is this correct

    1. Yes it is possible to a connection problem, can also be from your air bag, if it gets too much power then the airbag light will turn on, i seen a similar problem on a VW Lupo 999 Auc.

Leave a Reply

Your email address will not be published. Required fields are marked *