How to reset the mirror in the correct position Fiat Multipla

How to reset the mirror in the correct position Fiat Multipla.

Driving mirror.

This mirror is adjustable. Move lever (A) to shift the mirror to the following positions:

  1. standard position;
  2. anti-dazzle position.

The mirror is also fitted with a safety device that releases the mirror in the event of a collision.

Door mirrors.

These are divided into two sections.

A – upper mirror that can be adjusted from inside the car;

B – lower mirror that cannot be adjusted.

The fixed part of the left-hand mirror is panoramic, to cover any blind spots on the left side of the car.

Reset the mirror in the correct position Fiat Multipla

The fixed part of the right-hand mirror reflects the rear right wheel when parking.

This can only be adjusted with the ignition key at MAR. Use switch (C) to select the mirror (left, neutral, right) for adjustment. Press any of the four directions on switch (D) located on the ceiling light. Switch (E) electrically controls the movement of the folding mirrors from position 1 to position 2. Electrically folding mirrors have a demisting device that comes on automatically when rear window heating is turned on.

The mirrors can tilt in both directions in the event of a collision.

To reset the mirror in the correct position, first set it in the fully closed position by keeping the control pressed until the mirror stops, then open it.

If the mirror is moved out of its position manually, it is possible to set it back to the correct position manually, although it is preferable to move it electrically. If the mirror is moved out of its position electrically, it is COMPULSORY to set it back electrically to its correct position.

If the open mirror makes it difficult to pass through narrow gaps, fold it from position 1 to position 2.

When driving the mirrors shall always be in position (1).

As the door mirrors are curved, they may slightly alter the perception of distance.

Leave a Reply

Your email address will not be published. Required fields are marked *