How to change the fog lights on Chevrolet Silverado 2000-2006

How to change the fog lights on your Chevrolet Silverado made between the years 2000 and 2006. You will need the right socket wrench for this repair and no more than 10 minutes.

How to change the fog lights on Chevrolet Silverado 2000-2006

     This particular repair is very simple. You just have to go under the front of your car and look behind the front bumper. You will notice the fog light assembly held in place by two bolts, as shown below.  You will have to remove these bolts, using the socket wrench.

remove the bolts holding the fog light on Chevrolet Silverado 2000-2006

     After you remove the bolts, the assembly will come out very easily. At this moment, it is held only by its harness (as shown in the next picture). You will have to detach that cable in order to remove the fog light assembly.

disconnect the harness of the fog light on Chevrolet Silverado 2000-2006

     If you just need to service the light bulb, you don’t have to remove the whole assembly. You can rotate the socket of the bulb counterclockwise and install the replacement. But if you need to change the fog light assembly, connect the harness back, place the new piece inside the front bumper and tighten the two bolts that hold it. This is all you need to do, if you wish to change the fog lights on Chevrolet Silverado made between the years 2000 and 2006.

Leave a Reply

Your email address will not be published. Required fields are marked *